Specna Arms SA-B16 ONE™ SAEC™ Kestrel™ ETU - Noir

The rifle includes a factory-fitted ETU Kestrel V2 BASIC from E-Shooter. Easy Programming, only 3 steps to finished your wanted setting, reset all functions with 8 seconds trigger hold. Choose between 5 differents pre-cocking levels to programming, the Active Brake ensure piston stops in front position, and increase gearbox and inside parts' service life. Thanks to Low Battery Protection, when the battery is low, motor vibrates 5 times and blue light flashes 5 times at the same time.

The SA-B16 airsoft rifle has been made predominantly from a uniform zinc-aluminium alloy, with the use of steel components at the most critical points of the replica (so all screws, pins and the tactical sling mount are steel). The barrel, which houses the battery, as well as the pistol grip, are made of polymer. The body of the replica and the RIS rail assembly have been subjected to the anodising process, which guarantees a high degree of protection of the replica against corrosion. The painting of the replica itself was done by a powder coating process, after the surface had been sandblasted. This ensures that the applied paint is much more abrasion resistant than usual. The Specna Arms markings have been applied to the barrel.

The replica uses the new generation quick-change spring system, so called. SAEC™. This allows a quick and efficient adjustment of the replica's power to the conditions expected on the battlefield without the need for access to a workshop or a range of specialist tools. There is no need to pull the gearbox out of the replica - simply remove the buttstock and then unscrew the special pin located underneath it together with the spring guide bearing. The mainspring is replaced, the bolt is screwed back into the barrel, the butt is attached and... back in action!

It has been fully adapted to work with batteries of the type LiPo and LiFe. With a base initial discharge velocity of about ~430 FPS guaranteed by the factory-installed mainspring, the replica is perfectly suited for medium range operations.

The gearbox, reinforced at the height of the cylinder head, conceals a steel spring guide that is part of the SAEC™ System and mounted on 8mm ball bearings and washers steel gears. The system is secured with 4 anti-reverse pawls. The lightweight, polycarbonate polymer piston is provided with a set of steel teeth to increase its strength. It also uses cylinder type 2 and steel cut-off lever. The replica is factory-fitted with an accurate, rotating, polymer Hop-Up chamber which allows for very precise and stable adjustment of the BB under-cocking system.

• Zinc-aluminium alloy fabrication
• Anodized treatement for body and handguard
• SAEC™ new generation quick-change spring system
• Picatinny 22mm Handguard
• Renforced gearbox
• ETU Kestrel V2 BASIC - E-Shooter
• 14mm CCW thread

Inclus:

• 1x 300rds Hi-Cap magazine
• Foldable iron sights
• M90 additional spring
• Cleaning rod