3D6 M4 HPA Punisher Grip Stippling

This HPA M4 Grip is made by 3d printing technology, it is adding a nice touch on your HPA. The bottom of the grip has been reworked in order that the air line get a natural rear orientation. Compatible with all HPA systems with a 6mm macroline hose (or less outer diameter), be careful however only the hose can be slipped inside the grip, so it will be necessary to install US or EU connector after installation. Instructions: start by inserting your hose at the entrance of the grip in the sheath, and once out use the four fixing screws (included) to fix it on your replica. You can then finalize the installation by adding your HPA connector.